Core Services
Surface & Material
Damage & Restoration
Prevention & Protection
Specialty Services
Source-Specific Repair
Professional ice dam removal serving Clermont and surrounding areas.
Ice dam removal in Clermont is roof work done with steam, and interior work done with meters. The dam itself is a symptom: attic heat melting snow on the upper roof while the eave overhang — cold, exposed, and overhanging an unheated soffit — refreezes the runoff into a ridge that traps the next wave of meltwater. Behind that ridge, water backs up under the shingles and finds the deck, then the underside of the sheathing, then the insulation and the paper face of the ceiling below. By the time a stain shows on the finished ceiling, the cavity above has been wet for a while — and Clermont’s cold February keeps it that way. The removal method is specific. Steamers deliver low-pressure, high-temperature vapor that melts the ice on contact without forcing water under the shingles or cracking the deck. Chisels and hammers drive shingles loose and puncture sheathing; chemical melters stain the roofing and run off into gutters and landscaping. The crew works the dammed sections with steam, clears the eave and gutter so the next melt has somewhere to go, and then reads the interior — meters and thermal imaging across the ceiling cavities at the eave line, well past the visible stain, because water that traveled along the underside of the deck often never made it through the finish ceiling in the first place. The permanent fix sits above the roof: insulation depth, air sealing at the ceiling plane, and ventilation verified from soffit to ridge. Clermont’s 1960s Tansel Woods and Lincolnwood ranches, with their original attic insulation, are where that pattern repeats year after year — so the removal documents what was actually found up there: which bays were thin, which penetrations were leaking warm air. Extraction and drying run on the same readings as any other water event, ceiling repair follows once the cavity proves dry, and the prevention scope closes the loop. Water Damage Pros US removes Clermont ice dams on that standard — steamed, read, dried, and documented.
| Scope | Typical Range in Clermont | Notes |
|---|---|---|
| Steam removal | $400 – $2,000 | Roof size + access dependent |
| Gutter / downspout clearing | $150 – $600 | Ice-filled runs |
| Interior drying, one room | $800 – $4,000 | Cavities + ceiling |
| Ceiling repair after drying | Included or quoted | After verified dry |
| Insulation + air sealing | Quoted separately | Prevents the repeat |
The dam is the symptom; the attic is the cause. Steam clears this winter’s ridge, but the ridge rebuilds every February until the heat loss stops — a thin insulation run, a warm bypass at a vent stack, a soffit blocked by stored boards. Clermont’s older ranch stock repeats the pattern because the attic was built to a different standard. The work that ends the annual call is the one that reads the ceiling cavity correctly, dries it to numbers, and writes down exactly what was found above.
Ice dam removal through the pre-war core around Church and Ben Hur streets, Tansel Woods and Lincolnwood across the north end, the Robey school area on the south side, and the Crawfordsville Road (US 136) corridor — plus Speedway, Eagle Creek, and the Indianapolis west side, and Brownsburg over the Hendricks County line.
Steam, not chisels — and read the cavity while you’re at it. Call Water Damage Pros US: the dam steamed open, the eave cleared, the ceiling bays metered past the stain, and the attic findings written up so next February is different.
Fast, professional water damage restoration for homes and businesses — extraction, drying, and full repair.
Complete flood cleanup and restoration after rising water, storms, and overflow.
24/7 water extraction with truck-mounted pumps to remove standing water fast and limit damage.
Full structural repair and reconstruction after water damage — drywall, floors, and framing.
Detailed moisture inspection and assessment with thermal imaging to find hidden water damage.
Cut out, replace, and repaint water-damaged drywall so walls look new again.
An ice dam is a ridge of frozen meltwater at the roof edge that stops new meltwater from draining off — so the water backs up under the shingles and into the house. It forms when the upper roof is warm enough to melt snow while the eave overhang stays at or below freezing: the melt runs down, hits the cold edge, refreezes, and builds a dam that grows all day. Attic heat is the usual cause — insufficient insulation, air leaks from the living space, or a warm bypass at a vent stack lets the deck reach melting temperature while the soffit stays frozen. Clermont's 1960s ranch stock with older attic insulation is exactly where this pattern recurs.
With steam, not with chisels, salt, or a roof hammer. Steamers deliver low-pressure, high-temperature vapor that melts the ice on contact without forcing water under the shingles or cracking the deck — tools do the rest of the work slowly from the ground or from a safe walkable section. Chipping and pounding drives the shingles loose and can puncture the decking; chemical melters stain the shingles and run off into the gutters and landscape. After the dam is relieved, the eave and gutter get cleared so the next melt has somewhere to go, and the attic side gets assessed for the heat loss that built it.
Usually there is — the stain is the last thing to show. Water entering at the eave travels along the roof deck and the underside of the sheathing before it drips through the insulation into the ceiling cavity, where it soaks the batts and the paper face of the drywall. By the time a mark appears on the ceiling, the cavity above has been wet for a while, and Clermont's cold February air keeps it that way longer. The inspection reads the cavity with a meter and thermal camera rather than waiting for the stain to bloom, which is what catches the bays that never made it through the finish ceiling.
It will, if the heat loss that created it stays. The dam is a symptom of an attic that's too warm relative to the eave — so permanent repair is insulation and air sealing at the ceiling plane, plus verifying attic ventilation at the soffit and ridge. Removing the dam fixes this winter's blockage; sealing the bypasses fixes the pattern. The crew documents what the roof and attic showed during removal so the owner has a specific list — where the insulation was thin, which penetrations were leaking warm air — rather than a general recommendation to 'add insulation.'
Steam removal runs $400 to $2,000 depending on roof size, access, and how many eave sections are dammed. Gutter and downspout clearing runs $150 to $600 where ice has filled the run. Interior drying and ceiling repair for water that got in runs $800 to $4,000 as a single-room scope, or sits inside a larger estimate when several bays are affected. Attic insulation and air-sealing work to prevent recurrence is quoted separately — and is the line that stops the annual repeat.
Our certified technicians respond fast, assess the damage, and give you a clear plan — with no obligation and no up-front cost.